17/02/2023 00:06:12

ECU - Charge Port (Combo Adapter) (Retrofit)

Correction code 440151060.24NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Set the "Native Charge Port" value:
    1. In Toolbox, open the "Infotainment Dashboard".
    2. Select "Vehicle Configuration".
    3. Select "Read Config" and then click Run.
    4. Scroll down to the option "plc_adapter_type".
    5. Select "Native Charge Port".
    6. Select "Apply Changes" and then click Run.
  2. Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.