Handle - Exterior Release - Door - Rear - LH (Remove and Replace)
Correction code
11452002
0.60
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Nuts that attach the LH front door exterior release handle to the door |
 7 Nm (5.2 lbs-ft) |
|
Reuse |
Remove
- Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
- Remove the rear LH door glass. See Glass - Door - LH - Rear (Remove and Replace).
- Remove the LH rear window motor/regulator assembly. See Window Motor / Regulator Assembly - Rear - LH (Remove and Replace).
-
Disconnect the electrical connector from the LH rear door exterior release handle.
-
Remove the plugs (x2) that
covers access to the LH rear door exterior release handle nuts.
-
Remove the nuts that attach
the LH rear door exterior release handle to the door, and then remove the
handle from the door.7 Nm (5.2 lbs-ft)NoteDo not replace Nyloc nuts.TIpUse of the following tool(s) is recommended:
- 10 mm socket
- 6 in extension
Install
Installation procedure is the reverse of removal, except for the following:
- When a new handle is installed, or the removed handle is installed onto a new door, perform an adjustment of the handle. See Handle - Exterior Release - Door - Rear - LH (Adjust).