18/06/2021 09:46:10

Striker - Door - Rear - LH (Remove and Replace)

Correction code 11354002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH rear door.
  2. Mark the position of the LH rear door striker using masking tape.
  3. Remove the bolts that attach the LH rear door striker to the body, and then remove the striker from the vehicle.

Install

  1. Hand-tighten the bolts that attach the LH rear door striker to the body.
  2. Close the LH rear door and verify the door position; adjust the position of the striker and verify fitment, if necessary.
  3. Tighten the bolts that attach the LH rear door striker to the body.
    26 Nm (19.2 lbs-ft)
  4. Remove the masking tape from the body.
  5. Close the LH rear door.