2023-02-08

Webbing Guide Bar - Seatbelt - 1st Row - LH (Remove and Replace)

Correction code 20054302 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

  • 1133787-00-A Key, Seat Belt Release, Model 3

Torque Specifications

Table 1. Torque Specifications: GUID-AC3A3075-412A-4ED0-AAFB-7DEE7E97BAC3.html
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the seat belt webbing guide to the B-pillar, and then remove the guide from the B-pillar
5 Nm (3.7 lbs-ft)
  • 8 mm socket
  • ¼ in std ratchet
  • ¼ in torque wrench (installation only)
Replace

Remove

  1. Open the LH doors and lower the LH windows.
  2. Move front seats fully forward.
  3. Release the LH upper B-pillar trim and move it aside.
  4. Remove the bolts that attach the seat belt webbing guide to the B-pillar, and then remove the guide from the B-pillar.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)

Install

  1. Install the bolts that attach the seat belt webbing guide to the B-pillar, and then remove the guide from the B-pillar.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
  2. Fasten the LH upper B-pillar trim .
  3. Move LH front seat to original position.
  4. Close the LH doors and raise the LH windows.