Harness - USB - Car Computer to Glove Box (RHD) (Remove and Replace)
Correction code
17106852
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Open the front doors.
- Remove the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace).
- Remove the LH and RH air wave bezel caps. See End Cap - Air Wave - LH (Remove and Replace).
- Remove the main instrument panel decor trim. See Decor Trim - Instrument Panel - Main (Remove and Replace).
- Remove the LH middle A-Pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
- Remove the LH lower A-Pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
- Remove the glove box. See Glove Box - Without Knee Airbags (Remove and Replace).
- Disconnect the LH air wave duct thermistor connector.
- Remove the clips (x3) that attach the LH air wave duct, and then remove the duct.
- Disconnect the glove box USB cable from the car computer.
- Release the glove box USB harness clips (x2) and remove the harness from the vehicle.
Installation procedure is the reverse of removal.