22/04/2020 09:49:39

Light - Turn Signal / Fog - Front - LH (Remove and Replace)

Correction code 17404002 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Light - Turn Signal / Fog - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH front turn signal/fog light to the front fascia
2.8 Nm (2.1 lbs-ft)
  • Torx T25 socket
  • 4 in extension
Reuse

Remove

  1. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  2. Release the clips (x9) that attach the front portion of the LH front wheel arch liner to the vehicle, and then move the liner aside to perform the following steps.
  3. Disconnect the electrical connector from the LH front turn signal/fog light.
  4. Release the clips that attach the fascia electrical harness to the LH front turn signal/fog light.
  5. Remove the screws, and then release the tabs that attach the LH front turn signal/fog light to the front fascia.
    2.8 Nm (2.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • 4 in extension
  6. Remove the LH front turn signal/fog light from the vehicle.

Install

Installation procedure is the reverse of removal.

After reinstalling all components, adjust the front fog lights to specification. See Light - Fog - Front (Adjust).