12/10/2023 07:08:26

Bag Holder Hook - Underhood Storage Unit - LH (Remove and Replace)

Correction code 15241112 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the hood.
  3. Remove the bolt that attaches the LH bag holder hook to the frunk assembly.
    Tip: Press the lower part of the LH bag holder hook to access the bolt.
    Informational PurposesAn informational icon, calling your attention
    Note
    Newer vehicles may not be equipped with underhood storage unit bag hook covers.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
    • Ratchet/torque wrench
  4. Remove the LH bag holder hook from the frunk assembly.

Install

  1. Install the bolt that attaches the LH bag holder hook to the frunk assembly.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Newer vehicles may not be equipped with underhood storage unit bag hook covers.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 4 in extension
    • Ratchet/torque wrench
  2. Close the hood.
  3. Raise the LH front window and close the LH front door.