2020-05-27
Seal - Inner Belt - Rear Door - LH (Remove and Replace)
Correction code
11704102
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).
-
Release the clips that
attach the rear and front pieces of
the inner belt seal to the rear door, and then remove the rear and front pieces of
the inner belt seal.
-
Slowly peel the length of
the strip piece of the seal from the rear door.
Install
- Press the rear door inner belt seal downwards into the rear door.
- Install the clips that attach the inner belt seal to the rear door.
- Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Install).