09/07/2018 15:25:28

Harness - Subframe - Front (Remove and Replace)

Correction code 17101202 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Partially raise the vehicle to a comfortable working height. See Raise Vehicle - 2 Post Lift.
  2. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  4. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  5. Fullly raise the vehicle.
  6. Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  7. Release the grey locking tab, and then press on the tab to disconnect the front drive unit logic connector near the LH side of the front subframe.
  8. Release the locking tab, and then push the handle downward to disconnect the front drive unit inverter logic connector.
  9. Release the red locking tab, and then press down on the tab to disconnect the resolver logic connector.
  10. Release the grey locking tab, and then press down on the tab to disconnect the oil pump connector.
  11. Release the clip that attaches the front drive unit harness to the front drive unit motor.
  12. Release the clips that attach the front drive unit harness to the front subframe.
    Figure 1. Other assemblies hidden for clarity
  13. Release the clips that attach the front drive unit harness to the inverter.
  14. Remove the front drive unit harness from the front subframe.

Install

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Perform a push-pull test on the front drive unit harness connectors to verify that the connectors are fully attached.