Filler Neck - Reservoir - Windshield Washer (RHD) (Remove and Replace)
Correction code
17503102
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
-
Remove the bolt that attaches the filler neck to the underhood storage unit.
5 Nm (3.7 lbs-ft)
-
Release the clip that attaches the electrical harness to the filler neck.
- Pull the filler neck directly away from the windshield washer reservoir to remove it.
Install
Installation procedure is the reverse of removal, except for the following:
- Ensure the new filler neck is equipped with an O-ring. If an O-ring is not installed, install one.