01/08/2024 19:07:37

Module - Inductive Charger - Center Console (2.0) (Remove and Replace)

Correction code 15193902 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-04-20: Updated the number of the clips that attach the center console decor trim to the assembly.

Remove

  1. Open the front doors.
  2. Move the front seats fully rearward and into the lowest position.
  3. Pivot the center console armrest up.
  4. Use a plastic trim tool to carefully release the clips that attach the décor trim to the center console assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the surrounding clips first, and then release the upper portion of the trim.
  5. Disconnect the center console inductive charger module electrical connector, and then release the surrounding clips that attach the center console decor to the center console to remove the assembly from the center console.
  6. Remove the screws that attach the center console wireless charger module to the center console decor.
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
    • 4in extension
  7. Release the tabs that attach the center console wireless charger module to the center console decor, and then remove the module from the assembly.

Install

  1. Position the center console wireless charger module into the center console decor, and then secure the tabs.
  2. Install the screws that attach the center console wireless charger module to the center console decor.
    1.3 Nm (1.0 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T20 socket
    • 4in extension
  3. Connect the center console inductive charger module electrical connector, and then fasten the surrounding clips that attach the center console decor to the center console.
  4. Install the clips (x17) that attach the center console decor trim to the center console.
  5. Close the center console armrest.
  6. Move the front seats to the original position.
  7. Close the front doors.