2024-03-27

Sensor - Ride Height - Rear - LH (Remove and Replace)

Correction code 31036102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Sensor - Ride Height - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the LH rear ride height sensor to the LH rear upper aft link
10 Nm (7.4 lbs-ft)
  • 10 mm deep socket
  • Flex head ratchet/flex head torque wrench
  • Ratchet/torque wrench
Reuse
Nut that attaches the LH rear ride height sensor to the rear subframe
10 Nm (7.4 lbs-ft)
  • 10 mm deep socket
  • Flex head ratchet/flex head torque wrench
  • Ratchet/torque wrench
Reuse

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH rear wheel. See Wheel (Remove and Replace).
  3. Remove the nut that attaches the LH rear ride height sensor to the LH rear upper aft link.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
  4. Remove the nut that attaches the LH rear ride height sensor to the rear subframe.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
  5. Disconnect the electrical connector from the LH rear ride height sensor, and then remove the sensor from the vehicle.

Install

  1. Connect the electrical connector to the LH rear ride height sensor.
  2. Install the nut that attaches the LH rear ride height sensor to the rear subframe.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
  3. Install the nut that attaches the LH rear ride height sensor to the LH rear upper aft link.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
  4. Install the LH rear wheel. See Wheel (Remove and Replace).
  5. Remove the vehicle from the lift.