22/05/2018 13:27:16

Brake Lines - LH Sill (Remove and Replace)

Correction code 33035102 4.26 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1079041-00-A Flare nut crowfoot set

Remove

  1. Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION

    Brake fluid dissolves paint. Have clean towels and plenty of water standing by to wash spilled brake fluid off painted surfaces.

    Informational PurposesAn informational icon, calling your attention
    Note

    Dispose of used brake fluid in a manner consistent with local environmental codes.

  2. Remove the LH and RH lower rocker panel covers. See Cover - Rocker Panel - Lower - LH (Remove and Replace).
  3. Remove the HV battery. See HV Battery (RWD) (Remove and Install).
  4. Remove the LH front wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace).
  5. Remove the LH rear wheel arch liner. See Wheel Arch Liner - Rear - LH (Remove and Replace).
  6. Position the oil drain under the front brake line junction block.
  7. Remove the brake line tube nuts from the junction block. Allow the fluid to drain. Use a crowfoot extension to torque the nuts for installation.
    23 Nm (17.0 lbs-ft)
  8. Position the oil drain under the rear brake line junction block.
  9. Remove the brake line tube nuts from the junction block. Allow the fluid to drain. Use a crowfoot extension to torque the nuts for installation.
    23 Nm (17.0 lbs-ft)
  10. Remove the nut that attaches the rear junction block to the body, and separate the block from the body.
    7 Nm (5.2 lbs-ft)
  11. Release the clips that attach the brake lines to the body.
  12. Remove the brake lines from the vehicle.

Install

Installation procedure is the reverse of removal, except for the following:

  • Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION

    Replace all nyloc nuts.

    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning

    Do not work on an incorrectly supported vehicle.

  • Bleed the brake lines for the rear calipers. See Brake Fluid Bleed - One Caliper.