2023-12-14

Foam - Cushion - Driver Seat (Remove and Replace)

Correction code 13070102 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Install

  1. Install a new occupancy sensor onto the new seat cushion foam pad.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove adhesion protection, and then attach the occupancy sensor between the indication marks on the foam pad.
  2. Route the occupancy sensor connector through the foam pad, and then install the plastic casing onto the connector harness.
  3. Install the seat cushion heater mat onto the seat cushion foam pad.
  4. Install the driver seat cushion trim. See Trim - Cushion - Driver Seat (Remove and Replace)