08/04/2021 13:03:32

Switch - Back Rest and Cushion Adjust - Driver Seat (Remove and Replace)

Correction code 13015102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the driver seat outboard side shield. See Side Shield - Outboard - Driver Seat (Remove and Replace).
  2. Carefully release the clips that attach the seat cushion and seat back buttons to the driver seat backrest and cushion adjust switch, and then remove the buttons from the outboard side shield.
  3. Remove the screws that attach the driver seat backrest and cushion adjust switch to the outboard side shield, and remove the switch from the side shield.

Install

  1. Install the driver seat backrest and cushion adjust switch to the outboard side shield, and then install the screws that attach the switch to the side shield.
    1.7 Nm (1.3 lbs-ft)
  2. Install the seat cushion and seat back buttons to the outboard side shield, and then fasten the clips that attach the seat cushion and seat back buttons to the driver seat backrest and cushion adjust switch.
  3. Install the driver seat outboard side shield. See Side Shield - Outboard - Driver Seat (Remove and Replace).