22/05/2018 13:22:18

Pipes - Refrigerant - High / Low Pressure (Non-Heat Pump) (Remove and Replace)

Correction code 18204802 1.68 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Recover the A/C refrigerant. See A/C Refrigerant (Recovery and Recharge).
    Informational PurposesAn informational icon, calling your attention
    Note
    Completely recover the refrigerant before continuing this procedure.
  2. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  3. Remove the front fascia valance. See Valance - Front Fascia (Remove and Replace).
  4. Remove the nut that attaches the A/C suction line to the condenser fan module and remove the line.
    22 Nm (16.2 lbs-ft)
  5. Release the clips that attach the outer plenum to the inner plenum, and remove the outer plenum.
  6. Remove the nuts that attach the inner plenum to the HVAC assembly, and remove the plenum.
  7. Remove the nut that attaches the liquid line to the TXV, and remove the line from the TXV.
    22 Nm (16.2 lbs-ft)
  8. Remove the nut that attaches the liquid line to the compressor, and remove the line from the compressor.
    22 Nm (16.2 lbs-ft)
  9. Disconnect the harness connector from the low pressure transducer.
  10. Release the clip that attaches the lines to the superbottle.
  11. Remove the bolt that attaches the lines to the shock tower brace.
    5.5 Nm (4.1 lbs-ft)
  12. Remove the bolt that attaches the liquid line to the EXV chiller assembly, and remove the line from the EXV.
    22 Nm (16.2 lbs-ft)
  13. Remove the lines from the vehicle.