26/02/2018 14:43:43

Bracket - Hinge - Seat Back - 2nd Row - LH (Remove and Replace)

Correction code 13057402 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the LH 2nd row seat side bolster. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).
  3. Remove the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace).
  4. Release the clip that attaches the electrical connector to the hinge bracket.
  5. Remove the bolt that attaches the LH 2nd row seat back hinge bracket to the seat back, and then remove the bracket from the seat back.
    45 Nm (33.2 lbs-ft)

Install

Installation procedure is the reverse of removal.