19/06/2019 11:21:56

Harness - 12V Battery Positive (Remove and Replace)

Correction code 17106002 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  2. Remove the 12V auxiliary battery. See 12V/LV Battery (Remove and Replace).
  3. Remove the 12V battery bracket. See Bracket - 12V Battery (RWD) (Remove and Replace).
  4. Remove the bolt that attaches the thermal harness cover to the front body controller module, and then remove the cover from the module.
  5. Disconnect the thermal harness from the front body controller module connector.
  6. Release the clip that attaches the suction/liquid lines to the body near the TXV, and then move the electrical harness aside to gain access to the front body controller module.
  7. Remove the bolts (x9) that attach the front body controller module cover to the front body controller module, and then remove the cover.
  8. Remove and discard the nut that attaches the battery positive cable to the front body controller module, and then remove the cable.

Install

  1. Install the battery positive cable to the front body controller module, and then install a new nut to attach the cable to the module.
    8.5 Nm (6.3 lbs-ft)
  2. Visually inspect that the power cables exit the front body controller module neatly in their respective channels, and parallel to each other.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure that no cables or wires will be pinched when the front body controller module cover is installed.
  3. Install the front body controller module cover to the front body controller module, and then install the bolts (x9) that attach the cover to the module.
    6 Nm (4.4 lbs-ft)
  4. Connect the thermal harness to the front body controller module connector.
  5. Fasten the clip that attaches the suction/liquid lines to the body near the TXV.
  6. Install the thermal harness cover to the front body controller module, and then install the bolt that attaches the cover to the module.
    6 Nm (4.4 lbs-ft)
  7. Install the 12V battery bracket. See Bracket - 12V Battery (RWD) (Remove and Replace).
  8. Install the 12V auxiliary battery. See 12V/LV Battery (Remove and Replace).
  9. Install the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).