08/04/2020 10:29:35

Manual Release - Door - Rear - LH (Actuate)

Correction code 11358005 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Open Rear Door Using Manual Release Cable

Informational PurposesAn informational icon, calling your attention
Note
This procedure describes how to manually open the rear door on a vehicle that does not have 12V power.
  1. Remove the bolt that attaches the access panel to the underside of the armrest.
    6 Nm (4.4 lbs-ft)
  2. Release the clips that attach the access panel to the underside of the LH rear door armrest, and then remove the access panel from the vehicle.
  3. Use a pick to pull the manual release cable out from the opening under the armrest.
    Informational PurposesAn informational icon, calling your attention
    Note
    The manual release cable is hidden behind a small hole in the door panel.
    Informational PurposesAn informational icon, calling your attention
    Note
    The insulating foam may be damaged during this step. Check for and remove any fragments of the foam.
  4. Pull the manual release cable to open the LH rear door.
  5. Remove the insulating foam from the manual release cable.

Install

Installation procedure is the reverse of removal, except for the following:

Fold a new piece of 25 mm x 64 mm x 3mm adhesive foam over the manual release cable ring.