20/02/2020 17:44:25

Speaker - Dash - Center (Remove and Replace)

Correction code 21211602 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Speaker - Dash - Center (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that attaches the center dash speaker to the IP carrier
2.3 Nm (1.7 lbs-ft)
  • Torx T20 bit
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace).
  2. Remove the LH and RH middle A-pillar trims. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  3. Remove the LH and RH upper A-pillar trims. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  4. Remove the instrument panel speaker grille. See Grille - Speaker - Instrument Panel (Remove and Replace).
  5. Remove the screws that attach the center dash speaker to the instrument panel, and then remove the speaker from the instrument panel.
    2.3 Nm (1.7 lbs-ft)
  6. Disconnect the electrical connector from the center dash speaker connector, and then remove the speaker from the vehicle.

Install

Installation procedure is the reverse of removal.