23/03/2018 14:36:47

Antenna - Bluetooth Passive Entry - Front (Remove and Replace)

Correction code 17451102 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
  4. Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace).
  5. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  6. Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  7. Remove the front fascia valance. See Valance - Front Fascia (Remove and Replace).
  8. Remove the front fascia. See Fascia - Front (Remove and Install).
  9. Disconnect the electrical connector from the front Bluetooth passive entry antenna connector.
  10. Remove the bolt that attaches the front Bluetooth passive entry antenna to the front end carrier, and then remove the antenna from the front end carrier.
    9 Nm (6.6 lbs-ft)

Install

Installation procedure is the reverse of removal.