Harness - Door - Front - LH (Remove and Replace)
Correction code
17100102
0.78
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Partially raise the vehicle to a comfortable working height. See Raise Vehicle - 2 Post Lift.
- Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
- Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Install).
- Remove the LH front door speaker. See Speaker - Front Door - LH (Remove and Replace).
- Remove the LH front door closeout panel. See Closeout Panel - Door - Front - LH (Remove and Replace).
-
Release the locking tab, and
then disconnect the harness from the LH front door exterior release
handle.
Figure 1. Interior door skin hidden for clarity -
Disconnect the electrical
harness from the door latch connector.
-
Release the clips that
attach the LH front door harness to the LH front door.
- Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
- Remove the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
- Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
-
Disconnect the LH front
door harness connectors (x4) from the LH body controller
module.
-
Release the clip that
attaches the LH front door harness to the LH body controller module.
-
Release the grommet, and
then push the door wiring harness through the A-pillar bulkhead.
Figure 2. Release the grommet from the door frame Figure 3. Push the connectors through the bulkhead -
Push the wiring harness
connectors (x4) through the LH
front door bulkhead, and then remove the harness from the door.
Install
Installation procedure is the reverse of removal.