Connector - Pedestrian Warning Speaker (CN) (Remove and Replace)
Correction code
171007520.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the RH front wheel. See Wheel Assembly (Remove and Install).
-
Remove
the clips (x9) that attach the RH front wheel liner
to the fascia, and move the wheel liner aside for
access.
-
Remove
the clip that attaches the harness to the pedestrian
warning speaker assembly.
-
Release
the locking tab by sliding the red tab away from the
connector, then depress the locking tab to release
the pedestrian warning speaker connector.
NoteThe connector access may vary depending on the version of the super horn audio speaker installed on the vehicle. You may need to use a pocket screwdriver or a miniature pick to release the red locking tab, which is covered by an anti-tampering feature.
-
Remove the connector locking cover, and then press down
on the pins (x2) while pulling the harness downwards
to remove the connector from the vehicle.
Install
-
Insert the pins (x2) into the connector, and then
install the connector locking cover.
NotePerform a pull-push-pull test to verify the pins are fully seated.
-
Connect
the pedestrian warning speaker connector.
-
Install the clip that attaches the harness to the
pedestrian warning speaker assembly.
-
Install
the clips (x9) that attach the RH front wheel liner
to fascia.
- Install the RH front wheel. See Wheel Assembly (Remove and Install).