Plenum - Inlet - HVAC (Remove and Replace)
Correction code
18109102
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Remove the cabin intake duct. See Duct - Upper - Cabin Intake (Remove and Replace).
-
Release the clips that
attach the HVAC inlet plenum to the inner HVAC plenum duct, and then remove
the HVAC inlet plenum from the vehicle.
Install
Installation procedure is the reverse of removal, except for the following:
- Align the tab at the bottom of the HVAC inlet plenum before attaching the clips.