12/10/2018 18:17:54
Trim - Side Rail - LH (Remove and Replace)
Correction code 15186602 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH side rail trim. See Trim - Side Rail - LH (Remove and Install).
- Release the clips that attach the old LH side rail tethers to the LH side rail, and then remove and discard the tethers from the vehicle.
Install
- If not pre-installed, install new push clips (x2) onto the new LH side rail trim.
- Remove the new side rail trim tether clips from the new LH side rail trim.
-
Install the new side rail trim tether clips on the LH side rail.
CAUTIONDo not remove the clips after they are fully seated on the LH side rail. The clips are one time use.
- Hook the LH side rail trim tethers (x2) on the LH side rail trim, and then position the side rail trim on the side rail.
-
Firmly fasten the push clips that attach the LH side rail trim to the LH side rail.
NoteFasten the top clip first near the coat hanger, and work towards the trunk.Important: Make sure each clip makes an audible snap as they engage with the side rail. If there is no audible snap, the clip has not properly attached. Remove the side rail trim, inspect the clips, replace any damaged clips, and then re-install the trim.