25/10/2021 23:37:29

Bracket - Active Hood Strut - LH (Remove and Replace)

Correction code 11330012 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Bracket - Active Hood Strut - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the strut bracket to the wheel arch, from inside the wheel arch.
13 Nm (9.6 lbs-ft)
  • 10 mm socket
  • 2 in extension
  • Ratchet/torque wrench
Reuse
Bolt that attaches the strut bracket to the wheel arch, from on top of the bracket.
10 Nm (7.4 lbs-ft)
  • 6 mm hex
  • 2 in extension
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the actuator. See Actuator - Pedestrian Protection - LH (Remove and Replace).
  2. Use a small flat head screwdriver to release the clip that attaches the gas strut to the LH active hood strut bracket, and then remove the strut from the bracket.
  3. Remove the bolt that attaches the LH active hood strut bracket to the body, from inside the wheel arch.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
    • Ratchet/torque wrench
  4. Remove the bolts (x2) that attach the strut bracket to the body, from on top of the bracket, and then remove the bracket from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 6 mm hex
    • 2 in extension
    • Ratchet/torque wrench

Install

  1. Install the LH active hood strut bracket to the boday, and then installl the bolt attaches the bracket to the body, to on top of the bracket.
    13 Nm (9.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
    • Ratchet/torque wrench
  2. Install the bolt that attaches the LH passive hood strut bracket to the body, from inside the wheel arch.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 6 mm hex
    • 2 in extension
    • Ratchet/torque wrench
  3. Install the strut to the LH active hood strut bracket, and then use a small flat head screwdriver to fasten the clip that attaches the strut to the bracket.
  4. Install the actuator. See Actuator - Pedestrian Protection - LH (Remove and Replace).