Headliner (Non-Heat Pump) (Remove and Install)
    
    Correction code
    
                           15203101
                           0.66
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
      
                        
    
    
    
    
  
Remove
- Remove the LH side rail trim. See Trim - Side Rail - LH (Remove and Replace).
 - Push to open the LH rear coat hook.
 - 
          Pry open the LH rear coat
                        hook screw cover with a small flat head screwdriver.
          
 - 
          Remove the screw that
                        attaches the LH rear coat hook to the body.
          
 - 
          Release the clips that
                        attach the LH upper B-pillar trim to the vehicle, and then move the upper
                        B-pillar trim aside. See Trim - B-Pillar - Upper - LH (Remove and Replace).
          NoteDo not remove the trim from the seat belt.
 - Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
 - Remove the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
 - Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
 - Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
 - Remove the LH sun visor. See Sun Visor - LH (Remove and Replace).
 - Remove the LH sun visor check base. See Check Base - Sun Visor - LH (Remove and Replace).
 - Repeat step 1 through step 11on the RH side of the vehicle.
 - Remove the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).
 - Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
 - 
          Release the clips that
                        attach the headliner electrical harness to the LH A-pillar area.
          
 - 
          Disconnect the electrical
                        harness from the headliner connector.
          
 - 
          Release the clips that attach the headliner to the body.
          
 - 
          With the help of an
                        assistant, remove the headliner through the front passenger doorway and out
                        of the vehicle.
          
 
Install
- With the help of an assistant, move the headliner through the front passenger doorway and into the cabin.
 - 
          Install the headliner to the
                        body, and then fasten the clips that attach the headliner to the body.
          
 - 
          Connect the electrical
                        harness to the headliner connector.
          
 - 
          Fasten the clips that attach
                        the headliner electrical harness to the LH A-pillar area.
          
 - Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
 - Install the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).
 - Install the LH sun visor check base. See Check Base - Sun Visor - LH (Remove and Replace).
 - Install the LH sun visor. See Sun Visor - LH (Remove and Replace).
 - Install the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
 - Install the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
 - Install the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
 - Install the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
 - Install the LH upper B-pillar trim, and then fasten the clips that attach the trim to the vehicle. See Trim - B-Pillar - Upper - LH (Remove and Replace).
 - 
          Install the screw that
                        attaches the LH rear coat hook to the body.
2.5 Nm (1.8 lbs-ft) - 
          Close the LH rear coat hook
                        screw cover.
          
 - Close the LH rear coat hook.
 - Install the LH side rail trim. See Trim - Side Rail - LH (Remove and Replace).
 - Repeat step 7 through step 17on the RH side of the vehicle.