13/05/2020 16:45:59

Sill Plate - Front - LH (Remove and Replace)

Correction code 12051102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1049517-00-A Seam Roller, Silicone, 5"

Remove

  1. Open the LH front door.
  2. Use IPA wipes to clean around the sill plate.
  3. Apply masking tape around the perimeter of the sill plate to mark the installation positioning.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place the tape as closely around the sill plate as possible.
  4. Use a plastic trim tool to carefully pry up and bend the sill plate.
  5. While using pliers to pull up on the sill plate, use a retractable blade to cut through the adhesive.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To reduce the risk of personal injury, wear cut-resistant gloves while performing this operation.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage the vehicle trim or body.
  6. Use IPA wipes to clean off any remaining adhesive.

Install

  1. Remove the adhesive backing from the new sill plate.
  2. Using the masking tape as a guide, carefully place the new sill plate into place and press down on it to adhere it to the vehicle.
  3. Use a seam roller to fully wet out the adhesive.
  4. Remove the protective film from the sill plate.
  5. Remove the masking tape from the door sill.
  6. Close the LH front door.