04/09/2024 17:05:26

USB Hub - Center Console - Front (2.0) (Remove and Replace)

Correction code 21260412 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-06-20: Added step to release clips through slots with pick.
Figure 1. Model 3 shown; Model Y similar
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Remove

  1. Open the sliding bin lid of the center console.
  2. Release the clips (x2) through the slots with a pick, and then release the rest of the clips (x3) that attach the bottom of the USB hub to the center console.
  3. Disconnect the electrical harness from the USB hub connectors (x2), and then remove the USB hub from the center console.
  4. Remove the screws (x3) that attach the USB hub to the USB panel, and then remove the hub from the panel.

Install

  1. Install the USB hub to the USB panel, and then install the screws that attach the hub to the panel.
    1.1 Nm (.8 lbs-ft)
  2. Position the USB hub into the center console storage bin, and then connect the electrical harness to the USB hub connectors (x2).
  3. Move the USB hub to the rear of the center console, and then fasten the clips (x5) that attach the USB hub to the rear of the center console.
  4. Close the storage bin lid of the center console.