01/03/2023 00:31:47

Trim - A-Pillar - Middle - LH (Remove and Replace)

Correction code 15182602 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  2. Release the upper clip that attaches the LH middle A-Pillar trim to the vehicle, and then pull the trim upwards to remove it from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove any remaining LH middle A-pillar trim clips from the LH A-pillar, and if the LH middle A-pillar trim is to be later installed, remove the clip from the trim.

Install

  1. If reusing the same LH middle A-pillar trim, install a new clip onto the trim.
  2. Align the bottom tab, and then push the top clip to fully seat the LH middle A-pillar trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the door seal is on top of the trim.
  3. Install the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).