09/07/2021 08:55:42

Hinge - Hood - LH (Remove and Replace)

Correction code 11330302 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
  3. Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace).
  4. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  5. Remove the LH and RH wiper arms. See Wiper Arms (Remove and Replace).
  6. Remove the LH and RH shock tower covers. See Cover - Shock Tower - LH (Remove and Replace).
  7. Release the clips that attach the LH and RH hood hinge covers to the hood hinges, and then remove the LH and RH hood hinge covers.

    LH hood hinge cover shown, RH similar

  8. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  9. If replacing the LH hood hinge, remove the wiper motor. See Wiper Module (Remove and Replace).
  10. Support the hood in the open position.
  11. Remove the LH and RH hood gas struts. See Gas Strut - Hood - LH (Remove and Replace).
  12. Mark the position of the RH and LH hood hinges to the hood using masking tape.
  13. With an assistant, remove the hood support from the vehicle.
  14. Remove the hood. See Hood (Remove and Install).
  15. Use tape to mark the mounting location of the hinge on the body.
  16. Remove the bolts that attach the LH hood hinge to the body, and then remove the hinge from the vehicle.
    24 Nm (17.7 lbs-ft)

    LH hood hinge shown, RH similar

Install

Installation procedure is the reverse of removal.