Air Extractor - LH (Remove and Replace)
Correction code
18105302
0.90
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the rear fascia. See Fascia - Rear (Remove and Install).
-
Press downward at the top to
release the tabs that attach the air extractor to the body, then swing the
upper portion of the air extractor outwards, and then remove the air
extractor from the vehicle.
Install
-
Position the bottom edge of
the air extractor, and then swing the top portion of the air extractor until
is attached firmly by the 4 clips.
- Install the rear fascia. See Fascia - Rear (Remove and Install).