01/04/2024 13:56:36

BLE TPMS (Update Configuration)

Correction code 34041400 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  1. Connect a laptop with Toolbox 3 to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The vehicle connection is integrated into the drivers footwell cover. Open the Toolbox 3 website https://toolbox.teslamotors.com.
  2. In Toolbox, select the connection status icon at the top right corner, and then select "Connect Locally".
    Informational PurposesAn informational icon, calling your attention
    Note
    The icon will turn green when the vehicle is connected.
  3. Select the "Dashboards" tab, and then select "Infotainment Dashboard" from the left.
  4. Select "Vehicle Configuration".
    Informational PurposesAn informational icon, calling your attention
    Note
    Click Read Config, and then click Run to load the configuration values if they are not shown automatically.
  5. Scroll down to "tpmsType", and then select "Tesla Ble" from the drop down menu.
  6. Click Apply Changes, and then click Run to save the updated configuration.
  7. After the center display of the vehicle has rebooted, verify that the configuration changes are complete.
  8. Select "Actions/Autodiag" and search for "LEARN-TP-TYPE".
  9. Select the PROC_VCSEC_X_LEARN-TP-TYPESearch for routine in ToolboxVCSEC Learn TPMS Config action, and then click Run to make sure the gateway uses the BLE TPMS.
  10. Search for "CLEAR-LEARNT-TIRE-OFFSET".
  11. Select the PROC_DIR_CLEAR-LEARNT-TIRE-OFFSETSearch for routine in ToolboxReset Tire Estimates after Tire Rotation or ReplacementChassis / Alignment & Tires - Reset Learned Tire Values action, and then click Run to clear the stored tire sizes.
  12. Click Read Config, and then click Run to verify that the vehicle configuration change was performed.
  13. Disconnect the laptop from the vehicle.