2020-04-09

Grille - Fascia - Front (Remove and Replace)

Correction code 10011502 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Grille - Fascia - Front (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the front fascia grille to the front fascia
1.8 Nm (1.3 lbs-ft)
  • Torx T25 socket
  • 4 in extension
 Reuse

Remove

  1. Remove the front fascia. See Fascia - Front (Remove and Install).
  2. Release the clip and remove the ambient air temperature sensor from the grille.
  3. Release the clips that attach the electrical harness to the grille.
  4. Remove the screws that attach the grille to the front fascia.
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • 4 in extension
  5. Release the clips that attach the grille to the front fascia, and then remove the grille from the fascia.
    Figure 1. Top
    Figure 2. Bottom

Install

Installation procedure is the reverse of removal.