2024-09-04

Horn Assembly (Remove and Replace)

Correction code 17531202 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

    Torque Specifications

    Table 1. Torque Specifications: Horn Assembly (Remove and Replace)
    Description Torque Value Recommended Tools Reuse/Replace Notes
    Bolt that attaches the horn assembly to the front subframe
    12 Nm (8.8 lbs-ft)
    • 10 mm socket
    • 6 in extension
    		 Reuse Recommend flashlight for visibility

    Remove

    1. Turn the steering wheel fully to the left.
    2. Release the clips (x7) that attach the front portion of the LH front wheel arch liner to the vehicle, and then move the wheel arch liner towards the rear of the vehicle to perform the following steps.
    3. Remove the bolt that attaches the horn assembly to the front subframe.
      Informational PurposesAn informational icon, calling your attention
      Note
      Use of the following tool(s) is recommended:
      • 10 mm socket
      • 6 in extension
    4. Disconnect the electrical connectors (x2) from the horn assembly.
    5. Remove the horn assembly from the vehicle.

    Install

    1. Position the horn assembly for installation, and then connect the electrical connectors (x2) to the horn assembly.
    2. Install the bolt that attaches the horn assembly to the front subframe.
      12 Nm (8.8 lbs-ft)
      Informational PurposesAn informational icon, calling your attention
      Note
      Use of the following tool(s) is recommended:
      • 10 mm socket
      • 6 in extension
    3. Install the clips (x7) that attach the front portion of the LH front wheel arch liner to the vehicle.
    4. Center the steering wheel.