15/08/2024 00:41:51

Seat Back - 2nd Row - RH (Remove and Replace)

Correction code 13054102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Seat Back - 2nd Row - RH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the RH seat back hinge bracket to the vehicle
18 Nm (13.3 lbs-ft)
  • 13 mm socket
  • 4 in extension
Reuse

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the RH 2nd row seat side bolster. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).
  3. Release the clips that attach the bolster bracket, and the remove the bracket from the vehicle.
  4. Disconnect the electrical harness from the heated seat connector for the RH 2nd row seat back, if equipped.
  5. Remove the nuts that attach the RH seat back hinge bracket to the body.
    18 Nm (13.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 13 mm socket
    • 4 in extension
  6. Lift the right side of the RH seat back assembly up, move forward and to the right, and pull the inner pivot out of the LH seat back assembly.
  7. Remove the RH 2nd row seat back from the vehicle.

Install

Installation procedure is the reverse of removal.