01/04/2024 14:04:44

Sensor - Parking Distance - Outer - Front (Remove and Replace)

Correction code 17271022 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Informational PurposesAn informational icon, calling your attention
Note
Outer parking distance sensors are S1, S2, S5, and S6. Inner parking distance sensors are S3 and S4. See Sensor - Parking Distance - Inner - Front (Remove and Replace)

Remove

  1. Remove the front wheel that is closest to the front outer parking sensor that is being serviced. See Wheel Assembly (Remove and Install).
  2. Raise the vehicle to a comfortable working height.
  3. Remove the front wheel arch liner that is closest to the parking sensor that is being serviced. See Wheel Arch Liner - Front - LH (Remove and Replace).
  4. Disconnect the electrical harness from the parking sensor.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If the connector has a red-colored locking tab, DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
  5. Release the tabs (x2) that attach the front parking distance sensor to the front fascia, and then remove the sensor from the fascia.

Install

Installation procedure is the reverse of removal, except for the following:

Push the red locking tab towards the connector to engage the locking mechanism. DO NOT push down or pull up on the red locking tab.

Consult the parts catalog to determine the type of parking sensor installed on the vehicle. If the vehicle is equipped with Tesla USS, run the following Toolbox 3.0 routines in the order listed:

  1. TEST-RESET_PARKvia Toolbox: (link)
  2. PROC_USM_FRONT_PROGRAM-USS-ADDRESSESvia Toolbox: (link)via Service Mode: Driver Assist ➜ Sensors ➜ Program Front USS