23/10/2024 23:34:08

Horn - High Tone (Remove and Replace) (Heat Pump)

Correction code 1753010032 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Table 1. Torque Specifications: Horn - High Tone (Remove and Replace) (Heat Pump)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt securing the high tone horn to horn assembly bracket
9.5 Nm (7.0 lbs-ft)
  • 10 mm socket
  • Flex head ratchet/flex head torque wrench
Reuse

Remove

  1. Remove the horn assembly from vehicle. See Horn Assembly (Remove and Replace).
  2. Remove bolt securing the high tone horn to horn assembly bracket.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench

Install

  1. Install bolt securing the high tone horn to horn assembly bracket.
    9.5 Nm (7.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The high tone horn connector should be perpendicular to the bracket frame. Adjust high tone horn angle to avoid touching the low tone horn.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
  2. Install the horn assembly to vehicle. See Horn Assembly (Remove and Replace).