2024-09-04

Airbag - Driver (Remove and Replace)

Correction code 20010102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

  • 2023-03-23: Updated tool from " small flat-blade screwdrivers" to " valve core removal tool".
  • 2023-03-24: Updated text and added image of holes in underside of steering wheel hub.
  • 2023-06-06: Add the Valve Core Removal Tool to the tool list.
  • 2023-11-09: Added a note about how to use the Valve Core Removal Tool correctly.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 1143985-00-A Valve Core Removal Tool
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see Airbag and Supplementary Restraint System (SRS) Precautions.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Supplementary restraint system (SRS) components can be hazardous if not handled properly. See Airbag and Supplementary Restraint System (SRS) Precautions.

Remove

  1. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  2. Insert the valve core removal tool (1143985-00-A) into the holes in the steering wheel just far enough to compress the spring clip simultaneously, and then remove the driver airbag from the steering wheel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To avoid damaging the airbag connector and wiring, do not insert the tool too far into the holes.
    Informational PurposesAn informational icon, calling your attention
    Note
    Insert the valve core removal tool into the hole, gently lift the tool handle toward the steering wheel, and then continue to insert the tool to release the latch.
    Figure 1. Older Vehicles - Holes at lower sides of steering wheel hub
    Figure 2. Newer Vehicles - Holes underneath steering wheel hub
  3. Disconnect the driver airbag electrical connector from the steering wheel, and then remove the airbag from the vehicle.

Install

  1. Make sure that the lower horn bracket is properly secured to the steering wheel.
  2. Connect the driver airbag electrical connector to the steering wheel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the harness does not get caught between the airbag and the horn.
  3. Fully press the driver airbag into the steering wheel so that the spring clip attaches the airbag to the steering wheel.
  4. Connect 12V power. See 12V/LV Power (Disconnect and Connect).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  6. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).