TPMS (Sensor ID Tool Learn)
Correction code 34041100 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-09-11: Added note with links to update TPMS Tool firmware.
- 2023-11-01: Updated procedure and Toolbox routine.
Procedure
- Review the TPMS service tool profile.
- Connect to the vehicle with Toolbox 3.0. See Toolbox 3 (Connect and Disconnect).
- In Toolbox, select the Actions tab, and search for "TPMS Sensor Learn".
- Select the PROC_TPMS_X_TPMS-SENSOR-LEARNSearch for routine in ToolboxTPMS Sensor Learn RoutineChassis ➜ TPMS ➜ Learn IDChassis ➜ TPMS ➜ Learn ID Action.
- Use the TPMS service tool to read and record the wheel sensors in the order displayed on the tool's screen.
- In Toolbox, enter the TPMS sensor ID for each wheel from the TPMS Tool into the TPMS Sensor Learn ID form.
-
When the Sensor IDs for all 4 wheels have been entered into the Toolbox TPMS Sensor
Learn ID form, click Run.
NoteClick the "X" at the top of the window after the routine is complete.
- On the touchscreen, select Vehicle Info and select Remove Speed Limit.
- Disconnect the laptop with Toolbox from the vehicle. See .
-
Test drive the vehicle to at least 15
mph for a short distance to verify all four sensor values are displaying on the
touchscreen.
NoteTouch Controls > Service.NoteWhen the vehicle receives communication from the TPMS sensors with known IDs, it will quickly connect to them.NoteIf the tire pressures do not populate, rescan each TPMS sensor and try again.