2020-04-10

Cover - Rocker Panel - Lower - LH (Remove and Replace)

Correction code 12202602 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Cover - Rocker Panel - Lower - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the LH lower rocker panel cover to the body
5 Nm (3.7 lbs-ft)
  • 10 mm socket
  • 6 in extension
Reuse

Remove

  1. Release the LH lower rocker panel bolt covers.
  2. Remove the bolts that attach the LH lower rocker panel cover to the body.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 6 in extension
  3. Release the clips that attach the LH lower rocker panel cover to the front and rear wheel arch liners.
    Figure 1. Front
    Figure 2. Rear
  4. Release the clips that attach the LH lower rocker panel cover to the rocker panel, and then remove the cover from the panel.

Install

Installation procedure is the reverse of removal.