2023-04-19

Brightwork - Center Console (2.0) (Remove and Replace)

Correction code 15190252 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the front doors and lower the front windows.
  2. Move the front seats to their lowest and rearmost positions.
  3. Open the center console armrest fully.
  4. Use a plastic trim tool to carefully release the clips that attach the décor trim to the center console assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the surrounding clips first, and then release the upper portion of the trim.
  5. Disconnect the center console inductive charger module electrical connector, and then release the surrounding clips that attach the center console decor to the center console to remove the assembly from the center console.
  6. Remove the bolts (x14) that attach the brightwork to the center console.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  7. Use a plastic trim tool to release the locator tabs (x12) that attach the brightwork to the center console.

Install

  1. Fasten the locator tabs (x12) that attach the brightwork to the center console.
  2. Install the bolts (x14) that attach the brightwork to the center console.
    1.6 Nm (1.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Hexagon Torque Wrench (installation only)
  3. Connect the center console inductive charger module electrical connector, and then fasten the surrounding clips that attach the center console decor to the center console.
  4. Install the clips (x17) that attach the center console decor trim to the center console.
  5. Close the center console armrest.
  6. Move the front seats back to their orignal positions.
  7. Raise the front windows and close the front doors.