Actuator - Latch - Hood - Secondary (Remove and Replace)
     Correction code
    
                           11355302
                           0.18
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
    Correction code
    
                           11355302
                           0.18
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
      
                        
    
    
    
  
- 2023-04-25: Corrected link to frunk manual release tool.
Remove
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Remove the cabin intake duct. See Duct - Upper - Cabin Intake (Remove and Replace).
- Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace).
- Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
- 
          Release the secondary hood
                        latch actuator cable from the hood latch.
          NoteRelease the clip before removing the actuator cable from the latch arm.
- 
          Disconnect the electrical
                        connector from the secondary hood latch actuator.
          
- 
          Release the clip that
                        attaches the secondary hood latch actuator to the front end carrier. 
          
- 
          Remove the bolts that attach
                        the secondary hood latch actuator to the front end carrier, and then remove
                        the actuator from the vehicle.
          
Install
- 
          Install the bolts that
                        attach the secondary hood latch actuator to the front end carrier. 5 Nm (3.7 lbs-ft) 5 Nm (3.7 lbs-ft)
- 
          Connect the electrical
                        connector to the secondary hood latch actuator.
          
- 
          Install the clip that
                        attaches the secondary hood latch actuator to the front end carrier. 
          
- 
          Install the secondary hood
                        latch actuator cable to the hood latch.
          NoteSecure the cable end to the latch arm, and then attach the clip.
- Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
- Install the hood latch cover. See Cover - Hood Latch (Remove and Replace).
- Install the cabin intake duct. See Duct - Upper - Cabin Intake (Remove and Replace).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).