15/12/2023 01:27:24
NVH Pads - HV Battery (Install)
Correction code
16103101
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Install
Note
The labor time for installing the NVH pads does not take into account the time it takes to remove and install the HV battery. The correction code for removing and replacing/installing the HV battery should be added to the Repair Order separately.
- Use alcohol wipes to clean the top surface of the HV battery, and then allow to dry for 1 minute.
- Measure 180 mm from the base of the base of the Ancillary Bay and apply masking tape to mark the location.
- Place the NVH pad so that it is exactly centered between the raised portions of the HV battery top surface, and then apply masking tape to mark the location.
-
Install the NVH pads (x4) onto the top surface of the HV battery:
- Remove the masking tape from the top surface of the HV battery.