2023-05-25

Glove Box - Without Knee Airbags (Remove and Replace) (RHD)

Correction code 14056302 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove and secure the customer's belongings from the glove box, if needed.
  2. Remove the main instrument panel decor trim. See GUID-75FE7270-0C12-4110-A987-A0E1CAF6589A.html.
  3. Open the glove box.
  4. Remove the screws that attach the glove box to the IP carrier.
    Informational PurposesAn informational icon, calling your attention
    Note
    One screw may be inside the glove box and not visible in the following image.

    LHD shows, RHD similar

  5. Release the clips that attach the glove box to the IP carrier.
  6. Disconnect the electrical harness from the glove box solenoid connector, the damper connector, and the puddle light connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    2 of the electrical connectors are accessed from the bottom of the instrument panel.

    LHD shows, RHD similar

  7. Remove the glove box from the vehicle.

    LHD shows, RHD similar

Install

  1. Bring the glove box into the vehicle, and then connect the electrical harness to the glove box solenoid connector, the damper connector, and the puddle light connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    2 of the electrical connectors are accessed from the bottom of the instrument panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Route the electrical harness from the puddle lamp forward of the divider at the linkages.

    LHD shows, RHD similar

  2. Make sure that the glove box damper pin is fully seated, and not to bump the glove box damper when installing the glove box.
  3. Fasten the clips that attach the glove box to the IP carrier.

    LHD shows, RHD similar

  4. Install the screws that attach the glove box to the IP carrier.
    2.3 Nm (1.7 lbs-ft)

    LHD shows, RHD similar

  5. close the glove box.
  6. Install the main instrument panel decor trim. See GUID-75FE7270-0C12-4110-A987-A0E1CAF6589A.html.