29/04/2020 14:37:09

Armrest - Center Console (Remove and Replace)

Correction code 15192502 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Armrest - Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that attaches the cap of the arrest hinge pin to the center console
1.6 Nm (1.2 lbs-ft)
  • Torx T15 socket
  • 4 in extension
Reuse

Remove

  1. Remove and attach the customer's belongings from the armrest, if needed.
  2. Lower all the windows, and then move the LH and RH front seats forward.
  3. Remove the center console lower rear panel. See Panel - Lower Rear - Center Console (Remove and Replace).
  4. Remove the center console air vent panel. See Assembly - Rear Vent - Center Console (Remove and Replace).
  5. Remove the center console end panel. See End Panel - Center Console (Remove and Replace).
  6. Remove the screw that attaches the cap of the armrest hinge pin to the center console, and then remove the cap.
    1.6 Nm (1.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T15 socket
    • 4 in extension
  7. Open the armrest, and then use a flat screwdriver to release the spring from the hook.
  8. Close the armrest, and then tap towards the LH side with a hammer and pin to remove the armrest hinge pin from the center console.
    Informational PurposesAn informational icon, calling your attention
    Note
    The armrest must be closed before proceeding.
  9. Raise the armrest and remove it from the center console.

Install

Installation procedure is the reverse of removal, except for the following:

  • Before installing the armrest, make sure it is in the open position as it is fastened.
  • Align the slot of the armrest hinge pin with the tab in the armrest pivot hole.