2026-10-28

Actuator - Intake (Heat Pump) (Remove and Replace)

Correction code 18102012 FRT 4.38 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the HVAC assembly. See HVAC Assembly (Heat Pump) (Remove and Replace).
  2. Disconnect the electrical harness from the intake actuator connector.
  3. Remove the screws (x2) that attach the intake actuator to the HVAC module, and then remove the actuator from the HVAC module.
    2.3 Nm (1.7 lbs-ft)
    Note
    Use of the following tool(s) is recommended:
    • 6 mm socket
    • 4 in extension
    • Flex head ratchet/flex head torque wrench

Install

Installation procedure is the reverse of removal.