17/10/2023 18:49:28

Tesla Badge - Front (Remove and Replace)

Correction code 1205010032 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1453028-00-A KIT, BADGE REMOVAL
  • 1600744-00-B M3Y Front Badge Jig

Remove

Informational PurposesAn informational icon, calling your attention
Note
The badge cannot be reinstalled if removed. If the badge is removed for any reason, it must be replaced with a new part.
  1. Prepare the badge removal tool with approximately 60 centimeters of monofilament line.
  2. Tie slip knots at both ends of the monofilament line and attach them each to the center groove of a handle.
  3. With the hood closed, position the badge removal tool so that the monofilament line cuts under a corner of the front Tesla badge.
  4. Move the badge removal tool in a sawing motion to separate the front Tesla badge from the hood.
  5. Use IPA wipes to clean all adhesive residue and debris from the hood surface.

Install

  1. Open the hood partially, and place a folded shop towel over the latch to prevent the hood from closing.
  2. Install the front badge fixture over the hood and onto the striker, and then attach the fixture in place with tape.
  3. Peel the adhesive backing from the hood badge, align the badge protective film to the locating posts of the fixture, and then press the badge to the hood.
  4. Remove the protective film from the badge, and then remove the fixture from the hood.
  5. Remove the shop towel from the latch, and then close the hood.
  6. Replace the protective film over the badge, use a pressure roller to wet-out the badge, and then remove the protective film.
  7. Use an IPA wipe to clean the badge and any remaining debris.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that all edges of the badge are securely affixed to the hood surface.