13/12/2023 22:31:05

Sensor - Exterior Door Handle - Rear - LH (Remove and Replace)

Correction code 1145010162 FRT 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Sensor - Exterior Door Handle - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the sensor to the LH rear door exterior handle
1.2 Nm (.9 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • Torx T20 socket
  • Ratchet/torque wrench
 Reuse

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the LH rear door puddle light. See Puddle Lamp - Rear Door (Remove and Replace).
  4. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  5. Remove the LH rear door glass. See Glass - Door - Rear - LH (Remove and Replace).
  6. Disconnect LV power. See LV Battery - Li-lon (Disconnect and Connect).
  7. Remove the LH rear window motor regulator assembly. See Window Motor / Regulator Assembly - Rear - LH (Remove and Replace).
  8. Remove the LH rear door outer handle. See Handle - Exterior Release - Door - Rear - LH (Remove and Replace).
  9. Remove the screws (x2) that attach the sensor to the LH rear door exterior handle, and then remove the sensor from the handle.
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Torx T20 socket
    • Ratchet/torque wrench

Install

  1. Install the screws (x2) that attach the sensor to the LH rear door exterior handle.
    1.2 Nm (.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Torx T20 socket
    • Ratchet/torque wrench
  2. Install the LH rear door exterior handle. See Handle - Exterior Release - Door - Rear - LH (Remove and Replace).
  3. Install the LH rear window motor regulator assembly. See Window Motor / Regulator Assembly - Rear - LH (Remove and Replace).
  4. Connect LV power. See LV Battery - Li-lon (Disconnect and Connect).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  6. Install the LH rear door glass. See Glass - Door - Front - LH (Remove and Replace).
  7. Install the LH rear door puddle light. See Puddle Lamp - Rear Door (Remove and Replace).
  8. Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  9. Calibrate the LH rear window regulator. See Window Regulator (Recalibrate) (Module Reset/Reflashed).
  10. Raise the LH front window and close the LH front door.