End Cap - Instrument Panel - LH (Remove and Replace)
Correction code
1405010072
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Open the LH front door and lower the LH front window.
-
Partially release the lower section of the LH front primary door
seal.
-
Release the clips that
attach the end cap to the vehicle, and then remove the end cap from the
vehicle.
WarningWear cut-resistant gloves when performing this step to avoid personal injury.
Install
-
Position the end cap to the
vehicle, and then fasten the clips that attach the end cap to the
vehicle.
-
Install the lower section of the LH front primary seal to the vehicke and
make sure it is properly seated.
- Raise the LH front window and close the LH front door.